Pinging tcp/ip ethernet interfaces on the network – FANUC Robotics America GFK-1541B User Manual
Page 42
2-29
2
Pinging TCP/IP Ethernet Interfaces on the Network
PING (Packet InterNet Grouper) is the name of a program used on TCP/IP networks to test
reachability of destinations by sending them an ICMP echo request message and waiting for a
reply. Most nodes on TCP/IP networks, including the Series 90-30 CPU364, implement a PING
command.
You should ping each installed Ethernet Interface. When the Ethernet Interface responds to the
ping,
it verifies that the interface is operational and configured properly. Specifically it verifies
that acceptable TCP/IP configuration information has been stored to the Interface.
Pinging the Interface from a UNIX® Host or a PC Running TCP/IP Software
A ping command can be executed from a UNIX host or PC running TCP/IP (since most TCP/IP
communications software provides a ping command) or from another Ethernet Interface.* When
using a PC or UNIX host, the user can refer to the documentation for the ping command, but in
general all that is required is the IP address of the remote host as a parameter to the ping command.
For example, at the command prompt type:
ping 10.0.0.1
Determining If an IP Address Has Already Been Used
It is very important not to duplicate IP addresses.
To determine if you have configured your
Ethernet Interface with the same IP address as another node:
1.
Disconnect your Interface from the LAN.
2. Ping the disconnected Interface’s IP address. If you get an answer to the ping, then the
chosen IP address is already in use by another node. You must correct this situation by
assigning unique IP addresses.
* To use another GE Fanuc Ethernet Interface, refer to the PING command in GFK-1186,
TCP/IP Ethernet Communications for the Series 90 PLC Station Manager Manual.
® UNIX is a registered trademark exclusively licensed through X/Open Company LTD.
The document is for study only,if tort to your rights,please inform us,we will delete