10base-t port, 10base t port pinouts – FANUC Robotics America GFK-1541B User Manual
Page 207
ries 90™ PLC User's Manual
–
May 2002
GFK-1541B
B
10Base-T Port
The Series 90-30 CPU364 Embedded Ethernet Interface, the IC693CMM321-FG and later
versions, and the Series 90-70 Ethernet Interface (Type 2) are equipped with a 10Base-T port for
direct connection to a 10Base-T (twisted pair) network without addition of an external
transceiver. The 10Base-T port on the Ethernet Interface is connected to an external 10Base-T
hub or repeater by a twisted pair cable.
Your 10Base-T twisted pair cables must meet the applicable IEEE 802 standards.
This section provides the information you need to specify the 10Base-T twisted pair cables,
including 10Base-T port pinouts and cable diagrams.
10Base T Port Pinouts
The 10Base-T port is located on the front of the Ethernet Interface. This port is an 8-pin RJ-45
“modular phone jack” connector. It is used to connect the Ethernet Interface to a 10Base-T hub
or repeater.
Pin Number
Signal
Description
1
TD+
Transmit Data +
2
TD–
Transmit Data –
3
RD+
Receive Data +
4
NC
No connection
5
NC
No connection
6
RD–
Receive Data –
7
NC
No connection
8
NC
No connection
Note
Pinouts are provided for troubleshooting purposes only. 10Base-T cables are
readily available from commercial distributors. GE Fanuc recommends
purchasing rather than making 10Base-T cables.
The document is for study only,if tort to your rights,please inform us,we will delete