Ports on the cpu364 – FANUC Robotics America GFK-1541B User Manual
Page 32
2-19
2
Ports on the CPU364
RS-232, RJ-11 Port (Station Manager Port)
The Station Manager port uses a 6-pin, RJ-11 “phone jack” connector. This port is used to
connect a terminal or terminal emulator to access the Station Manager software on the Ethernet
Interface. It is also used to connect to the PC Software Loader in case the communications
software in the Ethernet Interface needs to be updated. An IC693CBL316 cable (or equivalent) is
needed to connect the terminal, emulator, or Software Loader to the Ethernet Interface (see
Appendix B, “Communications Ports Characteristics”). On earlier versions of the CPU364
module, this port was labeled “Port 1 RS-232.”
Ethernet Ports
There are two Ethernet ports on the CPU364. Only one port can be used at a time. The Ethernet
Interface automatically detects the Ethernet port in use; special configuration is not required.
AAUI (Transceiver) Port
The 14-pin AAUI port provides the electrical and mechanical interface to a user-provided IEEE
802.3 transceiver cable, which connects the AAUI Port to an external Ethernet-compatible
transceiver (see Appendix B, “Communications Ports Characteristics”, for the characteristics of
the AAUI Port and suggested transceivers). The external transceiver is directly connected to the
Ethernet cable.
Caution
Do not connect or disconnect a transceiver cable to the AAUI port while
power is applied to the PLC. This may blow the AAUI port fuse and/or
cause permanent damage to the Ethernet Interface.
10Base-T, RJ-45 Port
This 8-pin, RJ-45 port provides a direct connection to a 10Base-T (twisted pair) Ethernet network
without an external transceiver.
The document is for study only,if tort to your rights,please inform us,we will delete