Motorola DSP96002 User Manual
Page 168
10 - 2
DSP96002 USER’S MANUAL
MOTOROLA
Figure 10-1. OnCE
Block Diagram
10.2.2
Debug Serial Clock/Chip Status 1 (DSCK/OS1)
The serial clock is supplied to the OnCE
through the DSCK/OS1 pin when it is an input. The serial clock
provides pulses required to shift data into and out of the OnCE
serial port. Data is clocked into the OnCE
on the falling edge and is clocked out of the OnCE
serial port on the rising edge. When an output, this pin
in conjunction with the OS0 pin, provides information about the chip status describing why the debug mode
cannot be entered in response to an external request. The DSCK/OS1 pin is output when not in the Debug
Mode (until the acknowledge signal is issued to the Command Controller). When switching from output to
input, the pin is three-stated. In order to avoid any possible glitches, an external pull-down resistor should
be attached to this pin. During hardware reset, this pin is defined as an output and it is driven low. The max-
imum SCK frequency is one third of the system clock frequency.
OS1 OS0 Status
0 0 Normal state
0 1 STOP or WAIT state
1 0 Core busy state
1 1 Core or DMA busy state