Motorola DSP96002 - Manual (Page 442)

A - 254 DSP96002 USER’S MANUAL MOTOROLA
MOVE(C) Move Control Register MOVE(C)
Operation:
S3
→
D2
S2
→
D1
#xxxx
→
D1
X:<ea>
→
D1
X:<Rn+xxxx>
→
D1
S1
→
X:<ea>
S1
→
X:<Rn+xxxx>
Y:<ea>
→
D1
Y:<Rn+xxxx>
→
D1
S1
→
Y:<ea>
S1
→
Y:<Rn+xxxx>
Assembler Syntax:
MOVE(C) S3,D2
MOVE(C) S2,D1
MOVE(C) #Data,D1
MOVE(C) X: ea, D1
MOVE(C) X:(Rn+displacement),D1
MOVE(C) S1,X: ea
MOVE(C) S1,X:(Rn+displacement)
MOVE(C) Y: ea, D1
MOVE(C) Y:(Rn+displacement),D1
MOVE(C) S1,Y: ea
MOVE(C) S1,Y:(Rn+displacement)
Description:
Move the contents of the specified control register to the specified destination or move the specified source
to the specified control register. The control registers S1, S3, and D1 are the program controller registers
and may be moved to or from any other register or memory space. All operands are word operands. All
memory addressing modes plus Long Displacement addressing may be used.
If the system stack register SSH is specified as a source operand, the system stack pointer SP is postdec-
remented by 1 after SSH is read. If the system stack register SSH is specified as a destination operand,
the system stack pointer SP is preincremented by 1 before SSH is written. This allows the system stack
to be efficiently extended using software stack pointer operations.
See Section A.10 for restrictions that apply to this instruction.
CAUTION
See restrictions in Section A.10.6 concerning Rn, Mn, and Nn registers as a
destination.
CCR Condition Codes: