Motorola DSP96002 User Manual
Page 7
2 - 4
DSP96002 USER’S MANUAL
MOTOROLA
t0
t1
t2
t3
t0
t1
t2
tw
t2
tw
t2
t3
CLK
No Wait State
Instruction
Two Wait State Instruction
ing hardware reset and becomes a level sensitive or negative edge triggered, maskable
interrupt request input during normal instruction processing. MODA, MODB and MODC
select one of 8 initial chip operating modes, latched into the operating mode register
(OMR) when the
—
R
—
E
—
S
—
E
–
T pin is deasserted. If
—
I
—
R
—
Q
–
C is asserted syn-
chronous to the input clock (CLK), multiple processors can be resynchronized using the
WAIT instruction and asserting
—
I
—
R
—
Q
–
C to exit the wait state.
2.1.3 Power and Clock (39 Pins)
CLK
(Clock Input) - active high input, high frequency processor clock. Frequency is twice the
instruction rate. An internal phase generator divides CLK into four phases (t0, t1, t2 and
t3) which is the basic instruction execution cycle. Additional tw phases are optionally
generated to insert wait states (WS) into instruction execution. A wait state is formed by
pairing a t2 and tw phase. CLK should be continuous with a 46-54% duty cycle.
Quiet VCC (4)
(Power) - isolated power for the CPU logic. Must be tied to all other chip power pins ex-
ternally. User must provide adequate external decoupling capacitors.
Quiet VSS (4)
(Ground) - isolated ground for the CPU logic. Must be tied to all other chip ground pins
externally. User must provide adequate external decoupling capacitors.
Address Bus VCC(4)
(Power) - isolated power for sections of address bus I/O drivers. Must be tied to
all other chip power pins externally. User must provide adequate external decoupling
capacitors.
Address Bus VSS(8)
(Ground) - isolated ground for sections of address bus I/O drivers. Must be tied
to all other chip ground pins externally. User must provide adequate external decoupling
capacitors.
Data Bus VCC(4)
(Power) - isolated power for sections of data bus I/O drivers. Must be tied to all
other chip power pins externally. User must provide adequate external decoupling ca-
pacitors.
Data Bus VSS(8)
(Ground) - isolated ground for sections of data bus I/O drivers. Must be tied to
all other chip ground pins externally. User must provide adequate external decoupling
capacitors.
WS
WS