Kyocera KM-C830 - Manual (Page 110)

Section 7 COPIER MANAGEMENT
7-15
Default setting
* Insert tray
( Sort mode ON/OFF
(Output form)
) Eject destination
⁄ ACS adjustment
¤ Auto color
adjustment
‹ Drum refresh
› Rotate sort ON/OFF
Description
Sets the drawer that contains the paper which will be
fed in the insert sheet modes (page 6-26).
* No.3 and No.4 drawers can only be selected when
the optional Paper Feeder is installed in your
copier.
Sets the default setting for the sort mode at the time
power is turned on.
Sets the location for ejection of finished copies: the
copy eject tray (side) or the copy storage table
(inner).
Adjusts the level of detection between color and
black&white originals in the Auto Color Selection
mode (page 4-1).
Slight changes in color copying may take place if
your color copier is used over a long period of time.
If the color on the originals and that which appears
on the copies begins to differ greatly, use this
procedure to adjust the color.
This operation should be performed when high
humidity causes the copy image to become blurred
or faded. The operation will take approximately 5
minutes.
Selects between standard sorting (page 6-46) or
rotate-sorting (page 6-46) as the default sort mode
whenever the sort mode is selected.
* In order to use this setting, there must be
11" x 8 1/2 and 8 1/2 " x 11" [B5 and B5R or A4 and
A4R] paper set in the drawers. (8 1/2 " x 11" and
A4R paper can be loaded into the optional Paper
Feeder, while B5 paper can be set onto the multi-
bypass tray. However, 2-sided copies cannot be
made automatically when paper is being fed from
the multi-bypass tray.)
Available settings
Standard copiers
1 paper [SOURCE 1] –
4 paper [SOURCE 4] /
Bypass
Duplex copiers
2 paper [SOURCE 2] –
4 paper [SOURCE 4] /
Bypass
On / Off
Inner Eject / Side Eject
1 – 5
---
---
On / Off
Factory
setting
2 paper
[SOURCE 2]
Off
Inner Eject
1
---
---
Off
Reference
page
7-21
7-21
7-22
7-22
7-22
7-23
7-23