Kyocera KM-C830 - Manual (Page 93)

Section 6 FUNCTIONS
6-46
Since copying in this mode is performed after multiple originals are
scanned and memorized, copies can be sorted into the required
number of sets even without the optional Document Finisher.
NOTES
• If you do not have a Memory Copy Board installed as standard
equipment, the optional Memory Copy Board must be installed in
your copier in order to use this mode.
• If “On” is selected under “ › Rotate sort ON/OFF” on page 7-23 and
the size of the finished copies is set to 11" x 8 1/2 " [B5 or A4], the
orientation of each set of copies will be changed, thus making each
copy set easier to separate. In order to use this setting, there must
be 11" x 8
1/2 " and 8 1/2 " x 11" [B5 and B5R or A4 and A4R] paper
set in the drawers. (8 1/2 " x 11" and A4R paper can be loaded into
the optional Paper Feeder, while B5 paper can be set onto the multi-
bypass tray. However, 2-sided copies cannot be made automatically
when paper is being fed from the multi-bypass tray.)
1 Set the original(s) to be copied.
2 Press the Sort key to light the corresponding indicator.
21. Sorting automatically [Sort mode]
3 Enter the number of copy sets that you want to make and
press the Start key.
• If you set the originals in the optional DF, copying will start
automatically.
• If you set the original on the platen, go to the next step.
4 Replace the first original with the next one and press the
Start key.
* Carry out this step for all of the originals that you want to
copy.
5 Once all of the originals that you want to copy have been
scanned, press the Enter key.
Copying will start.
Inch specifications Metric specifications
Inch specifications Metric specifications
Inch specifications Metric specifications