Kyocera KM-C830 - Manual (Page 33)

Section 3 PREPARATIONS
3-11
Perform the following cleaning operation on the charger if black lines
appear on the copy image.
1 Open the front cover.
2 Grasp the green cleaning shaft (shown as 1 in the
illustration), pull it out slowly as far as it will go and then push
it back in all the way. Repeat this step 3 to 5 times.
3 Take the supplied grid cleaner out of its package and remove
the cap.
NOTE
The sponge portion of the grid cleaner contains fluid. Perform the
cleaning operation as quickly as possible to prevent it from drying out.
3. Cleaning the charger
4 With the sponge portion of the grid cleaner up, attach it to the
copier as shown in the illustration.
5 Push up on the main charger release lever (shown as 2 in
the illustration). Lift up slightly on the main charger (shown
as
3 in the illustration), slowly pull out the main charger as
far as it will go and then push it back in all the way. Repeat
this step 2 to 3 times.
6 Lift up on the main charger release lever and push the main
charger back into its original position in the copier.
1
2
3