Kyocera KM-C830 - Manual (Page 129)

Section 8 OPTIONAL EQUIPMENT
8-2
IMPORTANT!
• Be sure to set only a number of originals that is LESS than the level
indicator on inside of the rear insert guide. Also, DO NOT set
originals outside the acceptable range as this can cause the
originals to misfeed.
(See page 8-1 for details on acceptable originals.)
• To keep ejected originals from falling off the copier, open the
ejection extension when using larger sized originals such as 8 1/2 " x
14" and 11" x 17" [B4 and A3].
• When copying from 2-sided originals, the originals will be
temporarily ejected from the left cover in order to turn them over and
copy the reverse side. Do NOT touch them at this point! Any attempt
to remove them can cause the originals to misfeed.
● Setting originals in the SRDF
1 Adjust the original insert guides to fit the width of original(s)
to be copied.
NOTES
• Before copying, make sure that there are no originals remaining on
the original eject table. Originals left on the eject table can cause
other originals to misfeed.
• If you are setting multiple originals at one time, ALWAYS use
originals of the same size. It is, however, possible to use different
size originals of the same width (ex.: 11" x 8
1/2 " and 11" x 17" [A4
and A3]) at the same time if you use the auto selection mode. See
page 8-3.)
2 Arrange the originals in order and set them face up (front
side up for 2-sided copies) on the original table. The original
set indicator will light green. If the indicator doesn’t light, set
the originals once again.