Kyocera KM-C830 - Manual (Page 120)

Section 7 COPIER MANAGEMENT
7-25
Default setting
5 APS for special
paper ON/OFF
6 Color copy paper
location
7 Auto preheat time
8 Auto shut-off time
9 Display contrast
adjustment
Description
Sets whether the paper loaded in the drawer that
was selected under “
4 Special paper location” on
page 7-28 will be used or not in the auto paper
selection mode or in automatic drawer switching
(page 2-5).
Sets the location (a drawer or the multi-bypass tray)
where paper will be loaded for color copying. When
you make color copies in the auto paper selection
mode, copying will be performed onto paper that is
loaded in the drawer that you select here.
* No.3 and No.4 drawers can only be selected
when the optional Paper Feeder is installed in
your copier.
Sets the amount of time between the point that
copying ends and the energy-saving preheat mode
(page 6-47) engages.
Sets the amount of time that will elapse if no
operation is performed before the auto shut-off
function (page 6-48) engages and turns the copier
OFF (
). It is also possible to disable the auto
shut-off function. If the auto shut-off function is
turned OFF, this setting will not be effective. (See
“
3 Auto shut-off ON/OFF” on page 7-28.)
The factory default time is 30 minutes.
* It is recommended that you try to set a longer time
interval before auto shut-off engages if you use
the copier frequently, and to a shorter time if it is
used less frequently.
* In order to disable the auto shut-off function, see
“ 3 Auto shut-off ON/OFF” on page 7-28.
Adjusts the contrast of the LCD display if you
cannot see the message display clearly.
Available settings
On / Off
Standard copiers
Bypass /
1 paper [SOURCE 1] –
4 paper [SOURCE 4]
Duplex copiers
Bypass /
2 paper [SOURCE 2] –
4 paper [SOURCE 4]
5 minutes – 45 minutes
(5 minute increments)
15 minutes – 240
minutes (15 minute
increments)
1 – 7
Factory setting
On
-----
15 minutes
30 minutes
4 (middle setting)
Reference
page
7-29
7-29
7-29
7-29
7-30