Kyocera KM-C830 - Manual (Page 62)

Section 6 FUNCTIONS
6-15
(3) Selecting the erasing area (Custom erase mode)
With this mode, you can make clean, blemish-free copies from non-
standard size originals, i.e. sizes other than 8
1/2 " x 11", 11" x 17" [A4,
B4], etc. (The width of the border that will be erased is shown as a in
the illustration.)
NOTES
• The size of the original that is being copied must be registered in
advance. (See “ & Custom erase size” on page 7-21.)
• The illustration above shows how copies will be created when the
original is set on the platen.
1 Set the original to be copied.
NOTE
Set book originals as shown in the illustration.
NOTE
If you do not have a Memory Copy Board installed as standard
equipment, the optional Memory Copy Board must be installed in your
copier in order to use this mode.
(1) Erasing blemishes from edges of copies
(Sheet erase mode)
With this mode, shadows, lines, etc., that occur around the edges of
copies made from sheet originals can be erased. (The erased border
width is shown as
a in the illustration.)
NOTES
• The width of the border to be erased can be set to either 1/4", 1/2"
or 3/4" [6 mm, 12 mm or 18 mm].
• It is possible for you to change the default setting for the width of the
erased border. (See “ ^ Erased border width” on page 7-20.)
(2) Erasing blemishes from the edges and middle of
copies made from books (Book erase mode)
With this mode, you can make clean copies, even from thick books.
(The erased border width is shown as
a in the illustration.)
NOTES
• The width of the border to be erased can be set to either 1/4", 1/2"
or 3/4" [6 mm, 12 mm or 18 mm].
• It is possible for you to change the default setting for the width of the
erased border. (See “ ^ Erased border width” on page 7-20.)
6. Making copies with clean edges [Border erase modes]