Kyocera KM-C830 - Manual (Page 131)

Section 8 OPTIONAL EQUIPMENT
8-4
(4) Memory Copy Board
The Memory Copy Board is required in order to use the following
modes and functions of your copier.
• Margin mode
• Border erase modes
• Print page numbers mode
• Transparency + backing sheet mode
• Presentation mode
• Insert sheet modes
• Layout modes
• BW/Selection mode
• Poster mode
• Filing mode
• Sort mode
• Rotate copy function
• Copy management function
* The Memory Copy Board is standard in duplex copiers.
(5) Casters
These casters are for attaching to the bottom of your copier.
(2) Paper Feeder
This paper storage unit has two 250-sheet capacity drawers similar to
those included as standard equipment with your copier.
• Paper capacity (each drawer)
250 sheets (standard copy paper of a paper weight between 75 g/m 2
and 90 g/m 2 )
• Acceptable sizes of paper
8 1/2 x 11", 11" x 8 1/2 , 8 1/2 " x 14" and 11" x 17" [A5R, B5R, A4R, A4,
B4 and A3]
Paper is loaded in these drawers the same manner as with the
included drawers. (See page 3-1.)
* An access cover is included on the right side of the unit just in case
paper jams in either of these drawers.
* To prevent the copier from tipping over because of weight in the
copier and the upper paper drawers, the caster kit must be installed
at the bottom-most paper feeder, when an optional paper feeder is
installed with the copier.
(3) Document Finisher
The Document Finisher stores a large quantity of copies and can sort
multiple copy sets by shifting their position of ejection. it can also
staple the copy sets as well. For more details, refer to the Operation
Guide for the Document Finisher.
CAUTION
To prevent the possibility of accidents due to tilting
the copier body, always turn the desk’s stopper bolts
until they make firm contact with the floor during
initial installation or whenever the machine is moved.
CAUTION
To prevent the copier from tipping over, the optional
caster kit must be installed when the copier is
installed with an optional paper feeder.