Kyocera KM-C830 - Manual (Page 59)

Section 6 FUNCTIONS
6-12
1 Set the original to be copied.
NOTE
Set originals as shown in the illustration. Setting them in the wrong
direction may cause the margin to be created in the correct position.
2 Press the Digital Editing key to light the corresponding
indicator.
3 Use the ▲ cursor or the ▼ cursor key to select “x Margin”
and then press the Enter key.
The “Select Margin” [“SELECT MARGIN TYPE”] screen will
appear.
Inch specifications
Metric specifications
4 Use the ▲ cursor or the ▼ cursor key to select where you
want the margin to be created.
Inch specifications
Metric specifications
5 Press the Enter key.
• If you selected “z Left Margin” or “x Top Margin”, go to
the next step.
• If you selected “c F&B Margin”, go directly to step 9.
6 If you want to change the selected margin width, use the O
cursor or the P cursor key to select the desired width. If you
want to copy with the currently selected margin width, go to
the next step.
Inch specifications
Metric specifications
NOTE
The margin width can be set to any 1/8" increment between 1/4" and
3/4" [1 mm increment between 6 mm and 18 mm].
7 Press the Enter key.
8 Use the ▲ cursor key to select “z Enter” and then press the
Enter key. The message display will return to the “Ready to
copy.” screen.
Inch specifications Metric specifications