Kyocera KM-C830 - Manual (Page 119)

Section 7 COPIER MANAGEMENT
7-24
(3) Machine default settings
The following 15 machine default settings can be changed.
Change any or all of the settings as desired in order to make the most
effective use of your copier.
Default setting
1 Status report print
out
2 Auto drawer
switching ON/OFF
3 Auto shut-off
ON/OFF
4 Special paper
location
Description
Prints out a list of all machine default settings.
Sets whether the automatic drawer switching
function (page 2-5) will be used or not.
Sets whether the auto shut-off function (page 6-48)
will be used or not. The auto shut-off function
automatically turns the main switch OFF if no
operation has been performed on the copier for a
certain period of time.
* If auto shut-off interferes with your copying
operations, turn this function OFF. It is
recommended that you try to set a longer time
interval until auto shut-off engages before you
actually turn it OFF.
Sets the location (a drawer or the multi-bypass tray)
where recycled or special paper will be loaded.
* No.3 and No.4 drawers can only be selected
when the optional Paper Feeder is installed in
your copier.
* Be sure to load the type of paper selected under
“ % Type of paper” on page 7-31 in the location
selected here.
Available settings
-----
On / Off
On / Off
Standard copiers
Bypass /
1 paper [SOURCE 1] –
4 paper [SOURCE 4]
Duplex copiers
Bypass /
2 paper [SOURCE 2] –
4 paper [SOURCE 4]
Factory setting
-----
On
On
-----
Reference
page
7-28
7-28
7-28
7-28