Kyocera KM-C830 - Manual (Page 134)

9-1
Section 9 TROUBLESHOOTING
1. If one of the following messages is displayed
When any of the following messages appears on the message display, take the indicated action.
Message
“Close xxx cover.”
“CLOSE xxx COVER.”
“Add paper in drawer.”
“ADD PAPER IN DRAWER.”
“Set drawer.”
“CLOSE PAPER DRAWER.”
“Install duplex unit.”
“INSTALL DUPLEX UNIT.”
“Please Open Eject Tray”
“THICK PAPER MODE PROGRAM'D”
“Drawer inoperable. Call for service.”
“PAPER DRAWER IS OUT OF ORDER.
SELECT OTHER PAPER DRAWER.”
“Check paper size.”
“CHECK PAPER SIZE.”
“Reposi ori. or change drawer.”
“REPOSITION ORIGINAL OR SELECT
OTHER PAPER DRAWER.”
“Check bypass size setting.
Differ from actual size.”
“CHECK PAPER: NOT REGIST'D SIZE”
Procedure
The indicated cover is open. Close all covers securely.
There is no paper in the indicated drawer. Load paper of the
indicated size.
One of the drawers is not closed properly. First pull it out, and then
push it all the way back in.
(Only in duplex copiers) The Duplex Unit is not inserted properly.
First pull it out, and then push it all the way back in.
“x Side eject” is selected under copy default setting “ ) Eject
destination” (page 7-22), or the “z Transparency mode” or “x Thick
paper mode” are selected (page 3-5), but the copy eject tray is
closed. Open the copy eject tray.
The drawer currently in use is out of order and cannot be used for
the moment. Contact your service representative or an authorized
service center as soon as possible. If you want to continue copying,
use another drawer.
There is no paper loaded of a size that can be used in the currently
selected mode. Check the paper.
The orientation of the original and the selected paper are different.
Change the orientation of the original. If you press the Start key
without changing the original, copying will be performed at a 100%
(1:1) magnification ratio.
The size of the paper set on the multi-bypass tray and that loaded in
the drawer are different. press the Stop/Clear key to delete the error
message. Make sure the size of paper on the multi-bypass tray and
that loaded in the drawer are the same and restart the copy
operation from the beginning.
Reference
page
——
3-1
——
——
——
——
——
——
3-4