Kyocera KM-C830 - Manual (Page 135)

Section 9 TROUBLESHOOTING
9-2
Message
“Change bypass paper size”
“CHANGE BYPASS PAPER SIZE.”
“Exceeded copy quantity limit.”
“COPY LIMIT REACHED. NO COPYING”
“Set toner container.”
“SET TONER CONTAINER.”
“Ready to copy. Add toner. (KCMY)”
“READY TO COPY. ADD TONER. (KCMY)”
“Add toner to resume copying. (KCMY)”
“ADD TONER TO RESUME COPYING. (KCMY)”
“Ready to copy. Time to replace the oil kit”
“READY TO COPY. TIME TO REPLACE THE OIL
KIT.”
“Replace the oil kit now. Unable to copy.”
“REPLACE THE OIL KIT NOW. CANNOT COPY.”
“Check waste toner tank.”
“CHANGE WASTE TONER TANK.”
“Call for service.”
“CALL FOR SERVICE.”
“System error. Main switch off / on.”
“SYSTEM ERROR. MAIN SWITCH OFF / ON.”
“Time for maintenance”
“TIME FOR MAINTENANCE”
“Memory is full.”
“MEMORY IS FULL.”
Procedure
Copying is not possible at the paper size selected for the multi-
bypass tray. Change the paper size setting.
The number of copies made under your department code has
reached the limit that was set under the copy management mode
and copying is no longer possible with that code. Use the copy
management mode to clear the copy count.
One or more of the toner containers is not set or are not set properly.
Set the toner containers properly.
There is insufficient toner left in the indicated toner container.
Replace the corresponding toner cartridge as soon as possible
(C = cyan, M = magenta, Y = yellow, K = black).
The copier has run out of toner of the color indicated. Replace the
corresponding toner cartridge immediately (C = cyan, M = magenta,
Y = yellow, K = black).
It is almost time to replace the oil kit. Replace the oil roller as soon
as possible.
Replacement of the oil kit is required. Replace the oil roller
immediately.
• The waste toner tank is full. Replace the waste toner tank.
• The waste toner tank is not set properly. Set the toner waste toner
tank properly.
Open and then close the front cover. If this message still remains,
make a note of the number that displayed with the “C”, turn the main
switch OFF (
), and contact your service representative or
authorized service center.
An error has occurred. Turn the main switch OFF ( ) and then back
ON ( | ) again.
Periodic maintenance is required to keep your copier in good
condition. Contact your service representative or authorized service
center as soon as possible.
The copier’s memory is full. Select whether you want to print out that
data that is already scanned or delete all of that data. It will not be
possible to copy or scan another original until one of these two
operations is performed.
Reference
page
3-4
7-1
3-8
3-8
3-8
3-13
3-13
3-8
——
——
——
——