Kyocera KM-C830 - Manual (Page 130)

Section 8 OPTIONAL EQUIPMENT
8-3
● Setting originals on the platen
When copying from an original which cannot be set in the SRDF
(books, magazines, etc.), lift open the SRDF and set the original
directly on the platen.
1 Operate the SRDF release lever and open the SRDF.
* Before opening the SRDF, make sure that there are no
originals remaining on the original eject table. If there are
originals left on the eject table, they will fall off the copier
when the SRDF is opened.
2 Set the original to be copied face-down and align the edges
with the original size indicator lines.
3 Hold the SRDF release lever and close the SRDF.
IMPORTANT!
Do NOT put undue pressure on the SRDF when you close it or there
is a chance that you might break the platen glass.
● Auto selection mode
If you use the auto selection mode without pressing the Paper Select
key and specifying a desired paper size, originals will be checked on
by one for their size and the appropriate copy exposure, and paper of
the same size as each original will be selected automatically.
* You can set up to 30 originals in the SRDF in this mode.
* Only originals with the same width, such as 11" x 17" and 11" x 8
1/2 "
[A3 and A4] size originals can be used in this mode.
• Selecting the auto selection mode
1 Press the Auto Selection/Filing key to light the corresponding
indicator.
The “Select function” screen will appear.
2 Make sure that “z Auto select” [“z AUTO SEL.”] is selected
and press the Enter key.
The message display will return to the “Ready to copy.”
screen.
Inch specifications Metric specifications
CAUTION
DO NOT leave the document feeder open as there is
a danger of personal injury.