Kyocera KM-C830 - Manual (Page 52)

Section 6 FUNCTIONS
6-5
4 When copying is completed, press the Interrupt key once
again, and replace the newly copied original(s) with the
one(s) removed before. Then, press the Start key.
The interrupted copy job will be resumed. Interrupt copying is useful if, during one copy job, you want to copy
other originals at different settings. Once the rush job is completed,
the interrupted copy job can be resumed at the same settings as
before.
NOTE
Interrupt copying cannot be used to make copies in the transparency
mode, the transparency + backing sheet mode, the presentation
mode, the 2-sided copy modes or the insert sheet modes.
1 Press the Interrupt key. The Interrupt indicator will blink.
Wait a while until “Interrupt mode OK” [“INTERRUPT
MODE.”] is displayed and the Interrupt indicator lights
continuously.
2 Remove the original(s) that were currently being copied and
put it (them) aside.
3 Set the new original(s) and perform the desired copy
procedure.
Inch specifications Metric specifications
Inch specifications Metric specifications
2. Interrupt copying