Kyocera KM-C830 - Manual (Page 111)

Section 7 COPIER MANAGEMENT
7-16
(2) Accessing the copy default settings
1 Press the */Language key.
The “Default mode setting” [“SELECT SET ITEM”] screen will
appear.
2 Use the M cursor or the N cursor key to select “v Default”.
Inch specifications
Metric specifications
3 Press the Enter key.
4 Use the numeric keys on the keypad to enter the 4-digit
management PIN code “3000”.
Inch specifications
Metric specifications
NOTE
It is possible for you to change the 4-digit management PIN code.
(See “
0 Management PIN code” on page 7-30.)
Inch specifications Metric specifications
5 Use the M cursor or the N cursor key to select “c Copy
Default”.
Inch specifications
Metric specifications
6 Press the Enter key.
The “Copy Default” screen will appear.
7 Use the M cursor or the N cursor key to select the copy
default setting that you want to change. See “(1) Copy
default settings” on page 7-12 for information on the settings
that can be changed.
Inch specifications
Metric specifications
8 Press the Enter key.
9 Refer to and perform the following procedure that
corresponds to the setting that you want to change.
NOTES
• The arrow (>) displayed in the screen for each setting indicates the
current setting for that default.
• After you finish each setting, the display will return to the screen in
step 7. If you want to change any other settings, repeat steps 7
through 9.
10 Once you have finished making all of the default settings you
want, use the
M cursor key to select “End” and then press
the Enter key.
The message display will return to the “Ready to copy.”
screen.