Kyocera KM-C830 - Manual (Page 151)

Section 9 TROUBLESHOOTING
9-18
Trouble
The copy image is skewed.
Paper jams occur often.
Black lines appear on copies
when copying from the
optional DF.
Checkpoint
Were the originals set correctly?
Was the paper set correctly?
Is the copy paper loaded properly in the
drawer?
Is the copy paper curled, folded over or
wrinkled?
Is there any jammed paper or loose scraps
of paper remaining inside the copier?
Does the size of the paper actually set in the
multi-bypass match the size you selected in
the message display?
Is the slit glass dirty?
Procedure
When setting originals on the platen, align
them securely with appropriate original size
indicators.
When setting originals in the optional DF,
align the original insert guides securely
before setting the originals.
Set paper securely against the guide plates.
Load the paper properly.
Depending upon the type and condition of
the copy paper, finished copies can curl and
may be the cause of paper jams. Remove
the paper from the drawer, turn it over, and
set it in the drawer again.
Replace the copy paper with new paper.
Carry out the appropriate procedure to
remove the paper.
Make sure the size of the paper set in the
multi-bypass matches the size you select in
the message display.
Clean the slit glass.
Reference
page
4-1
8-2
3-1
3-1
——
3-1
9-4
3-4
10-1