Kyocera KM-C830 - Manual (Page 60)

Section 6 FUNCTIONS
6-13
9 Check the settings shown for the front & back margins. If you
want to create the margins at the current settings, press the
Enter key. In this case, go directly to step 19.
If you want to change the settings, go to the next step.
Inch specifications
Metric specifications
10 Use the N cursor key to select “x Change #”, and then
press the Enter key.
The “Select Front Margin” screen will appear.
11 Use the M cursor or the N cursor key to select where you
want the margin to be created.
Inch specifications
Metric specifications
12 Press the Enter key.
• If you selected “Left Margin”, “Right Margin”, “Top Margin”
or “Bottom Margin”, go to the next step.
• If you selected “No Margin”, go directly to step 15.
13 Use the O cursor or the P cursor key to select the desired
margin width.
Inch specifications
Metric specifications
NOTE
The margin width can be set to any 1/8" increment between 1/4" and
3/4" [1 mm increment between 1 mm and 18 mm].
14 Press the Enter key.
15 Use the M cursor or the N cursor key to where on the back
side of the copies you want the margin to be created.
Inch specifications
Metric specifications
NOTE
The margin position that can be selected for the back side will differ
depending on the margin position that is selected for the front side.
See the chart on page 6-11.
16 Press the Enter key.
• If you selected “Left Margin”, “Right Margin”, “Top Margin”
or “Bottom Margin”, go to the next step.
• If you selected “No Margin”, go directly to step 19.