Kyocera KM-C830 User Manual
Page 128
8-1
Section 8
OPTIONAL EQUIPMENT
(1) SRDF (Sheet-thru Reverse Document feeder)
Automatically feeds and scans multiple sheet-originals one by one.
Two-sided originals are automatically turned over so that both sides
can be scanned and copied.
● Acceptable originals
• Use sheet originals only
• Paper weight
One-sided originals: Use only originals with a paper weight of
between 35 g/m
2
and 160 g/m
2
.
Two-sided originals: Use only originals with a paper weight of
between 50 g/m
2
and 120 g/m
2
.
• Sizes
8
1/2
" x 5
1/2
" – 11" x 17" [A5R – A3]
• Number which can be set at one time
100 sheets (smaller than 11" x 8
1/2
" [A4] size, between 50 g/m
2
and
80 g/m
2
)
70 sheets (larger than 8
1/2
" x 14" [B4] size, between 50 g/m
2
and
80 g/m
2
)
(The maximum number of originals that can be set when using the
auto selection mode is 30 sheets.)
● Notes on acceptable documents
Be sure NOT to use the following as originals in the SRDF:
• OHP film or other transparencies.
• Soft originals such as carbon or vinyl paper, or other originals that
are badly curled, wrinkled or creased.
• Irregularly shaped originals, wet originals, or originals that have
adhesive tape or glue on them.
• Originals bound with clips or staples. (If you must use such originals,
be sure to remove the clips or staples, and straighten any curls,
wrinkles or creases, before setting them in the SRDF.)
• Originals with cut-out sections or that have a slippery surface on
either side.
• Originals on which any correction fluid is still wet.
• Originals with strong folds. (If you must use such originals, be sure
to smooth out the folds before setting them in the SRDF.)
* In addition, originals with punched holes or perforations should be
set so that the edge of the paper with the holes or perforations is
facing away from the SRDF.
● Names of parts
1 Original table
(Set originals to be copied on this table.)
2 Original insert guides
(Align these guides to fit the width of the originals to be copied.)
3 Left cover
(Open this cover if an original misfeed occurs.)
4 Original eject table
(Originals that have been copied are ejected and stored here.)
5 Ejection extension
(Open this extension when using larger sized originals such as
8
1/2
" x 14" and 11" x 17" [B4 and A3].
6 SRDF release lever
(Operate this lever when you want to open the SRDF.)
7 Original set indicator
(Indicated the status of originals set in the SRDF.
Lit green: Originals are set properly. Copying will begin when you
press the Start key.
Blinking green: Reset originals.
Blinking red: An original has jammed. See page 9-14 and removed
the jammed original.
1
7
2
3
2
5
4
6