Kyocera KM-C830 - Manual (Page 118)

Section 7 COPIER MANAGEMENT
7-23
5 Once print out is complete, set the printed color pattern on
the platen.
NOTES
• Set the PG color pattern on the platen so that the 3 squares are
located on the left side as shown in the illustration.
• Press the Stop/Clear key if you want to cancel the auto color
adjustment procedure.
6 Press the Start key.
The set PG color pattern will be scanned and auto color
adjustment performed automatically.
7 Once adjustment is completed, the “Auto Adjustment
(Text&Photo)” screen will appear.
Use the
M cursor or the N cursor key to select between
“z Adjust Finish” [“z ADJUSTMENT COMPLETED”],
“x Test Copy” and “c Adjust Again”.
Inch specifications
Metric specifications
• If you are finished with auto color adjustment, select
“z Adjust Finish” [“z ADJUSTMENT COMPLETED”] and
go to the next step.
• If you want to make a test copy, select “x Test Copy” and
go directly to step 10.
• If you want to perform auto color adjustment again, select
“c Adjust Again” and proceed directly to step 12.
8 Press the Enter key. The message display will return to the
screen in step 2.
9 Use the ▲ cursor or the ▼ cursor key to select “z End” and
then press the Enter key.
10 Press the Enter key.
11 Set an original and press the Start key. A test copy will be
printed out and the message display will return to the screen
in step 7.
12 Press the Enter key. The message display will return to the
screen in step 3. Repeat steps 4 through 7.
‹ Drum refresh
1 Press the Enter key.
The drum refresh operation will begin. Please wait about 5
minutes.
Inch specifications
Metric specifications
2 Once the drum refresh operation is complete, press the
Enter key.
› Rotate sort ON/OFF
1 Use the M cursor or the N cursor key to select either “z On”
or “x Off”.
Inch specifications
Metric specifications
2 Press the Enter key.