Kyocera KM-C830 - Manual (Page 124)

Section 7 COPIER MANAGEMENT
7-29
5 APS for special paper ON/OFF
1 Use the M cursor or the N cursor key to select either “z On”
or “x Off”.
Inch specifications
Metric specifications
2 Press the Enter key.
6 Color copy paper location
1 Use the M cursor or the N cursor key to select the location
(a drawer or the multi-bypass tray) where paper will be
loaded for color copying.
* The “1 paper” [“SOURCE 1”] drawer is not available in
duplex copiers.
Inch specifications
Metric specifications
2 Press the P cursor key. An asterisk ( ) will appear next to
the selected location.
If you want to cancel the designation, press the
O cursor key
and the asterisk will be deleted.
Inch specifications
Metric specifications
3 Use the M cursor or the N cursor key to select “End” and
then press the Enter key.
7 Auto preheat time
1 Use the M cursor or the N cursor key to select the amount
of time before the preheat mode engages. (The time can be
set to any 5 minute increment between 5 minutes and 45
minutes.)
Inch specifications
Metric specifications
2 Press the Enter key.
8 Auto shut-off time
1 Use the M cursor or the N cursor key to select the amount
of time before the auto shut-off function engages. (The time
can be set to any 15 minute increment between 15 minutes
and 240 minutes.)
Inch specifications
Metric specifications
2 Press the Enter key.