Kyocera KM-C830 - Manual (Page 35)

Section 3 PREPARATIONS
3-13
After approximately 25,000 copies, “Time to replace the oil kit.” or
“Replace the oil kit now” will appear. In this case, perform the
following procedure in order to replace the oil roller.
1 Open the front cover.
2 Operate the paper conveyor release lever and pull the paper
conveyor out towards you.
4. Replacing the oil roller
3 Slide the oil roller release levers (shown as 1 in the
illustration) away from the roller and then remove the oil
roller from the copier.
4 Remove the protective seals from each side of the new oil
roller.
5 Remove the new oil roller from its cover.
1
WARNING
High voltage is present in the charger section. Take
sufficient care when working in this area, as there is
a danger of electrical shock.
CAUTION
The copier’s fixing unit is extremely hot. Take
sufficient care when working in this area, as there is
a danger of getting burned.