Printronix Series 5 - Manual (Page 105)

4–52 Configuration Menus
Cancel IGP/DCU
CANCEL IGP/DCU has the following options:
•
ENABLE cancels all buffers when a job is put on hold from the host, or
the CANCEL key is pressed.
•
DISABLE does not cancel any internal buffer in the printer when a job is
put on hold from the host, or the CANCEL key is pressed.
PTX Transparent
You can enable additional features that are not available in standard Twinax
emulations. To access these features, send text commands in the data stream.
The commands must have a start and end code. Three sets (each containing a
start and end code) are available:
•
Set 1: start code = <%
end code = >
•
Set 2: start code = þþ
end code = $
•
Set 3: start code = _%
end code = _
Graphic Chek Err
GRAPHIC CHEK ERR allows overriding of the host setting of the SGEA (Set
Graphic Error Action) command. For more information about the SGEA
command, refer to the Programmer’s Reference Manual .
•
ENABLE is the host setting for the SGEA and is used by the printer. If
the SGEA command is requested to stop on graphic errors, the printer
will stop when a graphic error is detected.
•
DISABLE ignores the SGEA command from the host. The printer does not
stop when an error is detected; instead, it substitutes the character selected
in the “GRAPHIC CHEK CODE” menu entry.