Printronix Series 5 - Manual (Page 129)

4–76 Configuration Menus
Proprinter XL
Define CR Code
This option controls the action of the printer when it receives a Carriage Return
code (0D hex) from the host computer. If this feature is enabled, each time the
printer receives a Carriage Return, it inserts an additional Line Feed code (0A
hex) into the data stream. Do not use this feature if the host computer sends Line
Feeds to the printer.
•
CR = CR does not insert an extra Line Feed after each Carriage Return.
•
CR = CR + LF inserts an extra Line Feed after each Carriage Return.
Auto LF
This option defines the printer actions when print data is received past the forms
width setting.
•
Enable performs an automatic carriage return and line feed when data
is received past the forms width.
•
Disable discards any data past the forms width.
Define LF Code
This option determines whether an automatic carriage return should occur
whenever a line feed command is received.
•
LF = LF does not perform an automatic carriage return. The next print
position will be the current print position of the next line.
•
LF = CR + LF forces an automatic carriage return with each line feed
command. The next print position is position 1 of the next line.
FF Valid at TOF
The FF Valid at TOF option determines whether the printer will perform a Form Feed
when the host sends a Form Feed command, if the printer is at the Top of Form.
•
Disable will not perform a form feed when the host sends a Form Feed
command and the printer is at the Top of Form.
•
Enable performs a form feed when the host sends a Form Feed
command and the printer is at the top of form.