Printronix Series 5 - Manual (Page 95)

4–42 Configuration Menus
Char Set Select
CHAR SET SELECT specifies the print language used by the printer. Character
sets are shown in detail in the Character Sets Reference Manual .
Translation Table
TRANSLATION TABLE prints out SCS and DSC/DSE tables of coax interface’s
current character set. This operation is valid only when coax interface is the
current interface.
Active Char Set
This option selects which group of character sets will be active.
Prt Partial Line
When this option is enabled, it forces the printer to print if a partial line is in the
printer (i.e. line not ending with a LF). When disabled, the last partial line of data
will not be printed.
PA1
PA1 is only valid when the printer is in the NOT READY state and the coax
System Network Architecture Character Set (SCS) data stream is active. This
function displays the “PA1 ENABLED” message when the ENTER key is pressed
and sends a special operator request to the host when the printer is made
READY. Refer to the Programmer’s Reference Manual for more information
about SCS.
NOTE: Selecting the PA1 menu item again (“PA1 DISABLED” appears on
the operator panel) or selecting the PA2 menu item will reset the
pending PA1 function.
PA2
PA2 is only valid when the printer is in the NOT READY state and the coax SCS
data stream is active. This function displays the “PA2 ENABLED” message when
the ENTER key is pressed and sends a special operator request to the host
when the printer is made READY.