Printronix Series 5 - Manual (Page 96)

Configuration Menus 4–43
NOTE: Selecting the PA2 menu item again (“PA2 DISABLED” appears on
the operator panel) or selecting the PA1 menu item will reset the
pending PA2 function.
Buffer Reprint
This option is valid only when the printer is printing in SCS mode. When the
ENTER key is pressed, “Buffer Reprint Enabled” is displayed and an Intervention
Required status is sent to the host. Pressing ENTER again cancels the Buffer
Reprint function and “Buffer Reprint Disabled” is displayed.
Device ID
This parameter defines the printer emulation, as follows:
•
3287
•
4234
After the emulation has been changed, a POR status is sent to the host.
Early Print Complete
Early Print Complete capability allows the printer to send print (order) complete
status to the host before the printer is actually done printing all data. This option
is valid only when the printer is in DSC/DSE mode.
•
ENABLE means the printer will send an acknowledgement to the host
when it is able to accept more data.
•
DISABLE means the printer will suppress the Early Print Complete
response until all printing is complete.
NOTE: When an Early Print Complete is enabled and an error occurs,
there may be data loss experienced.
Cancel IGP/DCU
•
ENABLE cancels all buffers when a job is put on hold from the host or
when the CANCEL key is pressed.
•
DISABLE does not cancel any internal buffer in the printer when a job is
put on hold from the host, or when the CANCEL key is pressed.