Printronix Series 5 - Manual (Page 37)

2–26 Setting Up the Printer
Bearing Bracket
Paddle Shaft
4. Set the desired paper length (5–12 inch range), as follows:
Grasping the paddle shaft, push or pull toward the front or the rear of the printer,
setting the desired paper length by aligning indicator notch on the bearing
bracket with the paper length indicator.
5. Continue with the Loading and Starting the Power Stacker section.
Loading and Starting the Power Stacker
1. Using the rear control panel, press the PAPER ADVANCE key and hand feed
the paper in the paper throat. Continue to advance paper until paper reaches
the wire tent and there is an excess of 3–5 pages in the stacker. Be certain
the paper passes through paper stacker throat.