Printronix Series 5 - Manual (Page 231)

Index–4
Checksum calculation, Interleaved 2/5
bar codes, 4–90
CLEAR PAPER JAM message, 6–6
Clear to send (CTS) signal, RS–232
serial interface, 5–16
CLOSE PLATEN message, 6–6
Coax, emulations, 4–40
Coax interface menu
buffer print mode, 4–46, 4–56
Buffer Reprint, 4–43, 4–56
cancel IGP/DCU, 4–43
change case, 4–44
character set, 4–42
device ID, 4–43
early print complete, 4–43
format control, 4–46
host override, 4–45
image buf size, 4–45
intervention req, 4–45
PA1, 4–42, 4–56
PA2, 4–42, 4–56
PTX transparent control, 4–44
set text orientation, 4–44
translate table, 4–45
translation table, 4–42
Coax parameter, Print Partial Line,
4–42
Code chart, U.S. ASCII, C–1
COIL HOT, 6–6
Communication, bidirectional (1284),
5–9
Communication, Dataproducts
Longlines, 5–3
Communication, Dataproducts parallel,
5–5
Compatibility Mode, Parameters,
IGP/PGL, 4–24
Compatibility mode, 5–9
Compatibility options menu
auto skip at end, 4–49
CR at MPP+1, 4–47
CR, EM, and NL, 4–49
FF after job, 4–49
FF validity, 4–48
last char = FF, 4–48
NL at MPP+1, 4–47
null suppression, 4–48
position aft FF, 4–48
Component locations, 2–5
Compressed characters, Parameters,
IGP/PGL emulation, 4–23
Compressed print parameter, P-Series
XQ emulation, 4–70
Config. Control, menu, 4–15
Configuration, 4–29
menus
Epson FX–1050, 4–79
P–Series XQ, 4–69
page formatting parameters,
4–59
Proprinter XL, 4–76
Serial Matrix, 4–72
naming, 4–16
PGL, 4–18
terminating resistors, 5–13
Configuration Main Menu, 4–13