Printronix Series 5 - Manual (Page 244)

Index–17
Q
Quick Access Cover, 2–28
R
RAM, displaying, 4–118
Ready signal
Dataproducts Long Lines interface,
5–4
Dataproducts parallel interface, 5–6
Received CR, 4–86
Received data (RD) signal
RS–232 serial interface, 5–16
RS–422 serial interface, 5–17
Received Del, 4–86
Reloading Paper, 3–8
Replacing the Ribbon, 3–13
Report Status parameter
C/T Hotport, Auto Switching, 4–99
Parallel Hotport, Auto Switching,
4–99
Serial Hotport, Auto Switching, 4–99
Request to send (RTS) signal, RS–232
serial interface, 5–16
Request to Send parameter, 4–108
Requirements, printer, power, 2–2
Reset Cfg Name, 4–16
Resetting Configurations, 4–16
Resetting RibbonMinder, 4–119
Resistors
configuration, 5–13
installation, 5–14
removal, 5–14
Response Polarity
Centronics, 4–101
Dataproducts, 4–103
Response, idle, 4–109
Response, poll, 4–108
Reverse/Shaded Print, 4–28
Reversed print, 4–19
RIB INVLD CMD * message, 6–11
RIB INVLD STATE * message, 6–10
Ribbon
configuration menu, 4–119
installing, 2–17
size parameter, 4–119
specifications, A–2
RIBBON DRIVE message, 6–11
RIBBON INK OUT, CHANGE RIBBON,
6–11
RibbonMinder
fault message, 4–119
new ribbon, 4–119
ribbon action, 4–119
ribbon adjust, 4–119
ribbon size, 4–119
Rot. Char SIze, Graphics options,
IGP/VGL emulation menu, 4–33
Rotated Alphanumerics, 4–28
Rotated data, 4–19
RS–232 serial interface
clear to send (CTS), 5–16
data carrier detect (DCD), 5–16
data set ready (DSR), 5–16