Printronix Series 5 - Manual (Page 108)

Configuration Menus 4–55
SPC Coax Params
* = Factory default
SPC Coax
Params
Logical Buf Size Image Buff Size Buffer Print
Column 132
Wrap PA1
Intervention
Reg
Simp Prot Conv
Buffer Reprint PA2
1920*
960
2560
3440
3564 4K*
2K Send to Host*
Do Not Send Disable*
Enable
Disable*
Enable
Translation Tbl
Logical Buff Size
Refers to the size of the printer buffer which should be set the same as the host
screen (buffer) size. If the host screen size is unknown, use 1920.
Image Buff Size
This option refers to the printer base buffer size. This size must be set to a value
greater than or equal to the Logical Buffer Size.
Intervention Reg
Select SEND TO HOST to have the printer send a signal to the host whenever
any of the following events occur:
1. The printer faults.
2. HOLD Mode Time–Out
3. CANCEL PRINT key is pressed.