Printronix Series 5 - Manual (Page 232)

Index–5
Configuration menus
Auto Switching, 4–98
Centronics Parallel, 4–100
Config. Control, 4–15
Dataproducts Parallel, 4–102
Diagnostics, 4–116
Emulation, 4–39
ethernet, 4–111
Host Interface, 4–97
IEEE 1284 Parallel, 4–110
Maint/Misc, 4–91
Printer Control, 4–113
Serial Interface, 4–104
Configurations, IGP/VGL, 4–27
Configuring Emulations with the Control
Panel, 4–19
Connections
cord, 2–13
interface, 2–13
Control code 06 parameter
configuring with control panel, 4–64
P-Series XQ emulation, 4–69
Serial Matrix emulation, 4–72
Control code 08 parameter, configuring
with control panel, 4–64
Control Panel Keys
CANCEL, 3–5
CLEAR, 3–4
ENTER, 3–6
JOB SELECT, 3–5
ON LINE, 3–4
PAPER ADVANCE, 3–4
PREV + NEXT, 3–6
PREV or NEXT, 3–6
PRT CONFIG, 3–5
SET TOF, 3–5
UP + DOWN, 3–6
UP + ON LINE (IPDS Emulation
Only), 3–6
UP + PAPER ADVANCE (IPDS
Emulation Only), 3–7
UP + VIEW (IPDS Emulation Only),
3–7
UP or DOWN, 3–6
VIEW / EJECT, 3–4
Control panel overlays, attaching, 2–15
Cord connections, 2–13
CPI/LPI Select, 4–83
CPI/LPI, configuring, 4–59
CR at MPP+1, 4–47
CR, EM, and NL, 4–49
Creating character sets, 4–19
CTL VOLT FAIL * message, 6–6
D
Dark Barcode, Graphics options,
IGP/VGL emulation menu, 4–33
Data Bit 8, Ignore/DBS Setup options,
IGP/VGL emulation menu, 4–36
Data Bit 8 parameter
Centronics, 4–100
Dataproducts, 4–102
Data Bits parameter, 4–107
Data carrier detect (DCD) signal,
RS–232 serial interface, 5–16