Printronix Series 5 - Manual (Page 237)

Index–10
G
Graphic capabilities, 4–18
graphic capabilities, 4–19
Graphic Charsize parameter, 4–90
Graphic chek code parameter, 4–53
Graphic chek err parameter, 4–52
Scaling Capability, 4–19
Graphics options
IGP/VGL emulation menu, 4–31
UPC Descenders, IGP/VGL
emulation menu, 4–32
Graphics Quality parameter, 4–89
Graphics scaling, 4–89
GRF CHECK ERROR PRESS STOP
message, 6–7
H
HAM. COIL OPEN * message, 6–7
HAMMER COIL BAD, ### Message,
6–7
Hardware installation, unpacking
instructions
adjusting paper supports, cabinet
model, 2–8
attach output basket, pedestal
model, 2–10
paper chains release, cabinet model,
2–8
removing tags
cabinet model, 2–9
pedestal model, 2–9
HB NOT INSTALLD * message, 6–8
Hex 80–9F, configuring, 4–66
Hex code printout, 6–4
Hex Dump Mode parameter, 4–91
High speed print mode parameter,
P-Series XQ emulation, 4–70
Host interface menu, 4–97
Host override parameter
coax interface, 4–45
twinax interface, 4–53
Host PI, PI Control options, IGP/VGL
emulation menu, 4–37
Humidity requirements, 2–3, A–4
I
I 2/5 Checksum parameter, 4–90
Idle response, 4–109
Idle time, power saver mode, 4–114
IEEE 1284 interface, 5–9
menu, 4–110
operating modes, 5–9
pinout signals, 5–10, 5–11
signals, 5–12
IEEE menu, Buffer Size in K, 4–110
Ignore ch#1, Ignore/DBS Setup
options, IGP/VGL emulation menu,
4–36
Ignore ch#2, Ignore/DBS Setup
options, IGP/VGL emulation menu,
4–36
Ignore Dots, Graphics options,
IGP/VGL emulation menu, 4–31
Ignore mode, 4–24