Printronix Series 5 - Manual (Page 242)

Index–15
Pin assignments
Centronics parallel interface, 5–7
Dataproducts parallel interface, 5–3,
5–5
RS–232 serial interface, 5–16
RS–422 serial interface, 5–17
Pinout signals, IEEE 1284 interface,
5–10, 5–11
PLAT INV CMD * message, 6–10
PLAT INV PARM * message, 6–10
PLAT INV STATE * message, 6–10
Plot rates, A–8
PMD Fault parameter, 4–113
Poll character, 4–108
Poll Response, 4–108
Port Type parameter
C/T Hotport, Auto Switching, 4–98
Parallel Hotport, Auto Switching,
4–98
Serial Hotport, Auto Switching, 4–98
Pos. on BC/OvrSz, 4–86
Position aft FF, 4–48
Power
consumption, printer, A–6
input voltage, A–6
requirements, 2–2, A–6
Power Paper Stacker
Component Locations, 2–24
Loading and Starting, 2–26
Setting Up, 2–25
POWER SAVER MODE message,
6–10
Power Saver Time parameter, 4–114
Power Stacker, Unloading Paper, 3–11
Power–up configuration, parameter,
4–15
Power–up state, 4–92
Powering on the Printer, Printer
selftest, 3–2
POWERSUPPLY HOT * message, 6–9
PowerUp ^F, SFCC & Pwrup options,
IGP/VGL emulation menu, 4–31
PowerUp ^PY, SFCC & Pwrup options,
IGP/VGL emulation menu, 4–31
PowerUp ^X, SFCC & Pwrup options,
IGP/VGL emulation menu, 4–31
Prime Signal parameter
Centronics, 4–101
Dataproducts, 4–103
Ethernet, 4–110
Print Char Set, LinePrinter Plus menu,
4–62
Reset Cmd CFG Ld, LinePrinter Plus
menu, 4–62
Print Configuration parameter, 4–15
Print format menu
forms length, 4–83
forms width, 4–84
margins, 4–83
Print Partial Line
Coax parameter, 4–42
Twinax parameter, 4–51
Print speed, 4–89
Print Statistics parameter, 4–118