Panasonic MINAS E-series - Manual (Page 186)

186
Optional Parts
Connector Kits for Connection of Motor and Encoder
Used for: MUMA 50W to 400W Incremental
2500 pulse 5-wire
(1) Part No. DV0P3670
(2) Components
<Note>
You may use parts of other manufacturer equivalent to the above parts for such components as connector, connec-
tor cover, etc.
(3) Pin arrangement of connector CN X4 plug
(4) Recommended manual
pressure bonding tool
(A customer is requested to
provide it by himself.)
<Cautions>
1. The above figure shows the pin arrangement viewed from the soldering side of the connector.
Also check pin Nos. carved on the main body of the connector so as to avoid incorrect wiring.
2. Be sure to connect shield of the shielded wire to be used to the case (FG).
3. For wiring and connection, refer to “System Configuration and Wiring”, Connector CNX4 (Page 29).
Name
Connector
Connector (6P)
Connector pin
Connector (4P)
Connector pin
Connector (6P)
Connector pin
Manufacturer’s part No.
55100-0600
172160-1
170365-1
172159-1
170366-1
5557-06R-210
5556PBTL
Number
1
1
6
1
4
1
4
Manufacturer
Molex Incorporated
Manufactured by
Tyco Electronics AMP K.K.
Manufactured by
Tyco Electronics AMP K.K.
Molex Incorporated
Remarks
For connector CN X4
(pin 6)
For junction of encoder
cable (pin 6)
For junction of motor
power line (pin 4)
For connector CN X3
(pin 6)
Name
For junction of encoder cable
For junction of motor power line
For connector CN X3
Manufacturer’s part No.
755330-1
755331-1
57026-5000
57027-5000
Manufacturer
Tyco Electronics AMP K.K.
Molex Incorporated
Wire rod
–
UL1007
UL1015
6 Tx/Rx 5 Tx/Rx
2 0V 1 +5V
4 0V 3 +5V
(Case FG)