Panasonic MINAS E-series - Manual (Page 63)

63
[Preparations]
Preparations
SET
S Reveal execution display by pressing .
Keeping pressing (about 3 seconds)
increases number of “ ” as shown left.
Reading parameters and model
code from EEPROM of console
starts.
Checking whether parameters
can be transmitted to servo
driver starts.
Writing parameters into
EEPROM of servo driver starts.
Copying has finished normally.
<Note>
Do not disconnect the console cable from the servo driver during the proceeding from to
.
If the connector is disconnected during the time, wrong data will be written in and the data will be
crashed. In this occasion, copy the parameters from the copy source driver to the console, and then
copy the parameters from the console to the copy destination driver.
<Remarks>
If the error display appear repeatedly except for , that is presumably because of break of
cable, disconnection of connector, wrong operation due to noises, or failure of EEPROM of the console.
by pressing and .
Enter the copy mode by
pressing once and five
times in the initial state of LED,
and then bring in
SET
S M
MODE
Error display
SET
S
Keep pressing until the LED
display of the console is changed
to “ ”.
After finishing copying, return to Selection Display referring to “Structure of Each Mode” (Page 48 and 49).
The number
decreases
over time as
10, 9, 8, ----.
When the model code
read from console is
corresponded to the
model code of servo
driver.
When the model code
read from console is
different from the model
code of servo driver.
By keeping pressing
(about 3 seconds),
position of the decimal
point shifts to left as
shown on the left.
To cancel the copy,
press .
SHIFT
SET
S
<Note>
If this error display appears
during , a parameter
value read from the console is
out of range. In this occasion
check and modify the
parameters in the copy source
driver, and then copy the
parameters from the copy
source driver to the console,
and then copy the parameters
from the console to the copy
destination driver.
If this error display appears
except for , start the
operation from the beginning
again.
To cancel the error, press .
Copying parameters from console to servo driver (Copy Function)
Operation with Execution Display
Operations with Selection Display