Panasonic AG-HPX250EN - Manual (Page 109)

109
Editing
Nonlinear editing with P2 card (PC mode: USB device)
A USB 2.0 connection to a computer or other
device allows you to use P2 cards in the camera-
recorder as mass storage.
Procedures for making connections
to a personal computer
1
Connect a USB cable to the USB 2.0
connector.
A USB 2.0 cable is not supplied with the
AG-HPX250P/EN. Use a commercially
available USB cable (with shielding or
other noise-reduction measures) that
supports USB 2.0. (Page 102)
USB 2.0 Connector
(DEVICE)
2
Select USB Device in PC MODE SELECT on
the setting menu SYSTEM SETUP screen,
and press SET on the Operation lever.
• Refer to the section “Using the setup menus”
(Page 28 of Vol. 1) for menu operation.
PUSH MENU TO RETURN
REC FORMAT
CAMERA MODE
ASPECT CONV
SETUP
PC MODE SELECT
SCAN REVERSE
CAMERA
DVCPROHD/60i
7.5%A
USB DEVICE
24PA
OFF
LETTER BOX
REC SIGNAL
1080-59.9i SYSTEM MODE
SYSTEM SETUP
3
Press MENU twice to exit the menus.
4
Turn the POWER/MODE switch to the MODE
position to illuminate the PB/THUMBNAIL
lamp, and then turn and hold it.
• The PC lamp illuminates, the camera enters
PC mode, and video/audio output stops.
• You cannot switch to PC mode directly from
CAMERA mode. Leaves the thumbnail
screen of PB/THUMBNAIL mode.
To make a USB connection, you must first install
the P2 software on the supplied CD-ROM on the
computer. Select the “AG-HPX250” driver. This
USB driver supports only the Windows operating
system. For details, refer to the installation manual.
• A USB driver must be installed on the
computer.
• Use a computer that supports USB 2.0
since the camera-recorder supports only
USB 2.0.
• Connect only one camera-recorder to a
personal computer via USB.
• Do not remove P2 cards when the camera-
recorder is connect to a personal computer
via USB.
• In a USB connection, the P2 CARD ACCESS
LED is on only when the card is accessed.
• In USB device operation, recording,
playback and clip thumbnail operations are
not available.
• The free space and status of P2 cards is
not displayed when operating as a USB
device, and video/audio cannot be output
or displayed.
(Continued on the next page)