Panasonic AG-HPX250EN - Manual (Page 141)

141
Menu
Item Setting Notes
REC FUNCTION Sets special recording modes.
NORMAL:
The special recording modes are not used.
INTERVAL:
Sets interval recording.
ONE SHOT:
Sets one-shot recording.
LOOP:
Sets loop recording.
“Using special recording modes” (Page 43)
• This function is always set to NORMAL when the power
is turned on.
• Not available in the following
conditions.
· When REC SIGNAL is set to
1394
· When REC FORMAT is set to
native recording.
· When SYSTEM MODE is set
to 1080- 59.94i or 480-59.94i;
and CAMERA MODE is set to
24P or 24PA.
· When compiling to a clip in
one-clip recording mode.
· When VFR is set to ON.
ONE SHOT TIME Sets the duration for one-shot recording.
1frm, 2frm, 4frm, 8frm, 16frm, 1s
“One-shot recording (ONE SHOT REC)” (Page 45)
• Can only be set when REC
FUNCTION is ONE SHOT.
INTERVAL TIME Sets the time interval of interval recording.
2frm, 4frm, 8frm, 16frm, 1s, 2s, 5s, 10s, 30s, 1min,
5min, 10min
“Interval recording (INTERVAL REC)” (Page 44)
• Can only be set when REC
FUNCTION is INTERVAL.
START DELAY This delays the start of interval and one-shot recording by
about 1 second.
ON, OFF
• Can only be set when REC
FUNCTION is INTERVAL or
ONE SHOT.
PREREC MODE Sets PRE REC.
ON, OFF
“Pre-recording (PRE REC)” (Page 44)
• Not available in the following
conditions.
· When REC SIGNAL is set to
1394.
· When VFR is set to ON.
· When REC FORMAT is set to
native recording.
· When SYSTEM MODE is set
to 1080-59.94i or 480-59.94i;
and CAMERA MODE is set to
24P or 24PA.
· When REC FUNCTION is
set to something other than
NORMAL.
TC MODE Sets count correction when using the internal time code
generator.
DF:
Drop frame time code
NDF:
Non drop frame time code
“Setting the time code” (Page 66)
• Not displayed in 1080-50i, 720-
50P, 576-50i.
• Not available when operates
24P, 24PA or 24PN mode.
Counts NDF time code in 24P,
24PA or 24PN mode.
TCG Sets the mode in which you advance the time code.
FREE RUN:
The time code is advanced regardless of the operation
mode.
• In native recording in VFR mode, if the number of
frames differs for shooting and recording, the time code
changes to REC RUN.
REC RUN:
The time code is advanced only when recording.
RECORDING SETUP screen
___indicates the factory setting.