Panasonic AG-HPX250EN - Manual (Page 97)

97
Playback
When “USED” is selected:
3
5
4
1 2
1. Write-protect Mark
The mark appears if the P2 card is write-
protected.
2. P2 Card Status (used memory capacity)
The used memory capacity of the P2 card is
indicated by a bar graph and a percentage
figure. The bar graph indicator moves to the
right as the used memory capacity increases.
The following indications may appear,
depending on the card status:
FORMAT ERROR:
An unformatted P2 card is inserted.
NOT SUPPORTED:
An unsupported card is inserted in the camera-
recorder.
NO CARD:
P2 cards are not inserted.
Push the Operation lever in the   direction
to place the cursor on the P2 card for data you
want to access and press the SET button on the
Operation lever to display detailed information
about the P2 card to check individual information
such as the serial number and the user ID.
3. P2 Card memory capacity/Total Capacity
Displays the used memory capacity on a P2
card and the total capacity, in minutes. Because
fractions are truncated, the figure shown for
used memory capacity on a P2 card may differ
from the figure for total capacity.
The used memory capacity of a write-protected
P2 card is displayed as 100%.
During native recording with VFR, this changes
depending on the frame rate.
4. Total used memory capacity for all slots
Displays the total used memory capacity for all
2 slots.
Please note that the remaining capacity of a
writeprotected P2 card is not included in the
total remaining capacity.
When REC FUNCTION is set to LOOP, the slot
total indicates the standard recording time for
loop recording. However, when PROPERTY
SETUP → USED is selected, the used space
of the slot total is greater than that actually
used, and is less than that actually used when
PROPERTY SETUP → REMAIN is selected.
5. Warning symbol
When the following P2 card is detected, the
symbol is displayed.
RUN DOWN CARD:
The maximum number of overwrites on the
P2 card has been exceeded.
DIR ENTRY NG CARD:
The directory structure on the P2 card is not
supported.
The warning can be confirmed on the P2 card
detailed information indication in “2. P2 Card
Status (used memory capacity)” (Page 97).