Panasonic AG-HPX250EN - Manual (Page 132)

132
Item Setting Notes
LOAD/SAVE/INIT Loads, saves and initializes settings of the scene file
assigned to the current scene dial position (one F1 – F6
scene file).
LOAD:
Loads data stored in camera-recorder memory.
SAVE:
Saves current values in camera-recorder memory.
INITIAL:
Returns settings to their factory defaults.
• A change in scene files affects
only the scene file at the
current scene dial position.
• This setting cannot be made
when REC SIGNAL is 1394.
• Not available when compiling
to a clip in one-clip recording
mode.
VFR Enables or disables variable frame rate (VFR) mode at
1080i or 720P.
ON:
VFR operation
OFF:
*1
VFR off
• Not displayed when system
mode is 480i/576i.
• This setting cannot be made
when REC SIGNAL is 1394.
• Cannot be set when 1080i is
selected with DVCPRO HD
recording and CAMERA MODE
is not set to 60i, 50i.
FRAME RATE Adjusts the frame rate and exposure time at 1080i or
720P when VFR is on.
• 1080-59.94i:
1, 2, 4, 6, 9, 12, 15, 18, 20, 21, 22, 24, 25, 26, 27, 28,
30 FRAME
• 1080-50i:
1, 2, 4, 6, 9, 12, 15, 18, 20, 21, 22, 23, 24, 25 FRAME
• 720-59.94P:
1, 2, 4, 6, 9, 12, 15, 18, 20, 21, 22, 24, 25, 26, 27, 28, 30,
32, 34, 36, 40, 44, 48, 54, 60 FRAME
• 720-50P:
1, 2, 4, 6, 9, 12, 15, 18, 20, 21, 22, 23, 24, 25, 26, 27, 28,
30, 32, 34, 37, 42, 45, 48, 50 FRAME
• Can only be set when VFR is
ON.
• This setting cannot be made
when REC SIGNAL is 1394.
• A change to 24 fps may
cause the screen to flicker
momentarily.
SYNC SCAN
TYPE
Selects synchro scan shutter display.
sec:
Displays the shutter speed in fractions.
deg:
Displays the approximate shutter opening angle.
• Brightness may change when
settings are switched.
(SYNCHRO
SCAN)
Displays synchro scan shutter speeds to enable the
operator to synchronize the camera-recorder to computer
monitors.
• This function only displays the shutter speeds. Use the
SHTR/F.RATE dial to set a shutter speed.
• Set values (displayed values) are assigned to the
current scene file and manipulated using the LOAD,
SAVE and INIT functions.
“Setting SYNCHRO SCAN mode” (Page 50)
1/60.0 (AG-HPX250P)
1/50.0 (AG-HPX250EN)
• Displayed in blue when not
set to synchro scan mode and
when the SHTR/F.RATE dial
settings are not available.
DETAIL LEVEL Adjusts the level of image outline correction (in horizontal
and vertical directions).
– 7 …0 *1 … +7
V DETAIL LEVEL Adjusts the level of correction in vertical direction.
– 7 …0 *1 … +7
Setup menu list
SCENE FILE screen
Menu
*1: The factory default when the SCENE FILE dial is set to F1.
___indicates the factory setting.