Panasonic AG-HPX250EN - Manual (Page 49)

49
Shooting
Adjusting the shutter speed
Setting SHUTTER mode
1
Push DIAL SEL to select SHUTTER mode.
2
Push the SHTR/F.RATE dial.
• The SHUTTER mode changes ON/OFF.
• The shutter speed changes by turning the
SHTR/F.RATE dial in the shutter mode ON.
(Page 50)
• Remember that the faster the shutter speed,
the lower the sensitivity.
• It will take longer to focus when the shutter
speed has been reduced so it is recommended
that the unit be secured to a tripod, etc. for
use.
• The screen may be distorted when changing
the SYNCHRO SCAN or SHUTTER setting.
• Under fluorescent lighting and other discharge
lighting systems, horizontal stripes may appear
on the screen. Changing the shutter speed
may correct this problem.
• A subject that is captured when moving quickly
across the field of view may appear distorted.
This is due to the signal read out format of
the image sensor (MOS sensor) and is not a
malfunction.
• The red, blue and green dots that may appear
on the screen at low shutter speeds (1/6 to
1/15) do not indicate a malfunction.
Shutter speed is set using the SHTR/F.RATE dial
and DIAL SEL button.
As well as the shutter speed, you can use the
SHTR/F.RATE dial to select settings for synchro
scan and frame rate.
Using SHTR/F.RATE dial
DIAL SEL button
SHTR/F.RATE dial
Press the SHUTTER button.
• The function of the SHTR/F.RATE dial changes in
the following order.
SHUTTER → SYNCHRO SCAN →
FRAME RATE → LOCK → SHUTTER →
• SYNCHRO SCAN can be selected when the
SHUTTER is set to SYNCHRO SCAN.
SYNCHRO SCAN is displayed only when the
SHUTTER is set to SYNCHRO SCAN.
• FRAME RATE can be selected when the mode is
1080i or 720P.
To prevent accidental operation, DIAL LOCK
is automatically applied when no operation is
performed for approximately 12 seconds.