Panasonic AG-HPX250EN - Manual (Page 91)

91
Playback
Example of recording (DVCPRO HD) a clip on
one P2 card:
Recording pause REC start
Recording duration = Approx. 7 min.
Clip 1
COUNT value
= 0001
Clip 2
COUNT value
= 0002
5 min. 2 min.
Example of recording a clip on two P2 cards:
Recording pause REC start
Clip 1
COUNT value
= 0003
Clip 2
COUNT value
= 0004
1st card 2nd card
If the clip thumbnails are displayed as shown in the
example above or their properties are indicated
using a P2 device, the thumbnail and COUNT
value of clip 1 will be displayed.
Clear the uploaded metadata
Select META DATA → INITIALIZE from the
thumbnail menu, and press the SET button on the
Operation lever. A YES/NO confirmation screen
asks you to confirm that you want to initialize.
Select YES using the Operation lever to initialize
META DATA and clear the data read.
Formatting a P2 card
1
Turn the POWER/MODE switch to set to PB/
THUMBNAIL mode.
The thumbnail screen appears on the LCD
monitor.
2
Press the MENU button and select
OPERATION → FORMAT from thethumbnail
menu.
• When the screen shown below appears,
select the slot number of the P2 card you
want to format and press the SET button on
the Operation lever.
• Select EXIT if formatting is not required.
3
The following screen appears. Use the
Operation lever to select YES.
The selected P2 card is formatted.
Check that no important data remains on a
card before formatting since data erased by
formatting cannot be recovered.