Panasonic AG-HPX250EN - Manual (Page 142)

142
RECORDING SETUP screen (continued)
Item Setting Notes
TC PRESET Sets the initial time code.
• Set the frame value to 0 or multiples of 5 when shooting/
recording is set to 24P, 24PA, or 24PN.
If any other value, the recorded time code will mis-
match.
UB MODE Sets the data recorded in the camera-recorder user bits.
USER, TIME, DATE, EXT, TCG, FRM. RATE
“Setting user bits” (Page 62)
UB PRESET Sets the user information. Select USER in UB MODE.
ONE CLIP REC Sets one-clip recording mode.
ON, OFF
“One-clip recording (ONE CLIP REC)” (Page 47)
• Not available in the following
conditions.
· When REC FUNCTION is
set to something other than
NORMAL.
· When REC SIGNAL is set to
1394.
· When VFR is set to ON.
START TEXT
MEMO
Sets whether to automatically add a text memo at the
recording start position each time you start recording.
ON, OFF
• Not available when REC
FUNCTION is set to something
other than NORMAL.
• The text memo that is added
when this is set to ON indicates
the recording start position.
For details on recording the text
memo as text information, refer
to “Setting of clip meta data”
(Page 87).
TIME STAMP Determines whether or not date and time information will
be superimposed on the image.
ON:
Superimposes date and time information on the image.
OFF:
Does not superimpose date and time information on the
image.
<Note>
When DATE/TIME on the DISPLAY SETUP screen
is set to OFF, the date and time information is not
superimposed.
Setup menu list (continued)
___indicates the factory setting.