Panasonic AG-HPX250EN - Manual (Page 96)

96
Contents of P2 card status display
settings
From the thumbnail menu, select PROPERTY →
CARD STATUS. The following screen appears.
When “REMAIN” is selected:
3
5
4
1 2
1. Write-protect Mark
The mark appears if the P2 card is write-
protected.
2. P2 Card Status (remaining free space)
The remaining memory capacity of the P2 card
is indicated by a bar graph and percentage.
The bar graph indicator moves to the left as the
remaining free space decreases.
The following indications may appear,
depending on the card status:
FORMAT ERROR:
An unformatted P2 card is inserted.
NOT SUPPORTED:
An unsupported card is inserted in the camera-
recorder.
NO CARD:
P2 cards are not inserted.
Push the Operation lever in the   direction
to place the cursor on the P2 card for data you
want to access and press the SET button on the
Operation lever to display detailed information
about the P2 card to check individual information
such as the serial number and the user ID.
3. P2 Card Remaining Capacity/Total Capacity
Displays the P2 card remaining capacity and
total capacity in minutes. The total of the
remaining memory capacity for each P2 card
that is displayed may not match the actual total
remaining memory capacity for the P2 cards
because only the figure in minute is displayed.
During native recording with VFR, this changes
depending on the frame rate.
4. Total remaining free space for the slot
Displays the total remaining free space for all 2
slots.
Please note that the remaining capacity of a
writeprotected P2 card is not included in the
total remaining capacity.
When REC FUNCTION is set to LOOP, the slot
total indicates the standard recording time for
loop recording. However, when PROPERTY
SETUP → USED is selected, the used space
of the slot total is greater than that actually
used, and is less than that actually used when
PROPERTY SETUP → REMAIN is selected.
5. Warning symbol
When the following P2 card is detected, the
symbol is displayed.
RUN DOWN CARD:
The maximum number of overwrites on the P2
card has been exceeded.
DIR ENTRY NG CARD:
The directory structure on the P2 card is not
supported.
The warning can be confirmed on the P2 card
detailed information indication in “2. P2 Card
Status (remaining free space)” (Page 96).
Thumbnail operations (continued)