Panasonic AG-HPX250EN - Manual (Page 52)

52
Switching audio input
INPUT1 switch
(MIC POWER +48V)
INPUT1 LINE/MIC switch
INPUT2 LINE/MIC switch
INPUT2 switch
(MIC POWER +48V)
AUDIO CH2 SELECT switch
AUDIO CH1
SELECT switch
AUDIO INPUT 1/2 terminal
Using the built-in microphone
1
Switch the AUDIO CH1 SELECT switch to
INT (L).
• Audio from the built-in microphone Lch is
recorded to audio channel 1.
2
Switch the AUDIO CH2 SELECT switch to
INT (R).
• Audio from the built-in microphone Rch is
recorded to audio channel 2.
During shooting, you can record up to four
channels of sound. You can also switch the input
sound to be recorded on each of the channels to
the built-in microphones, external microphones or
audio equipment connected to camera-recorder.
(See table below.)
CH1
SELECT
switch
CH1 recording CH3 recording
INT (L) Built-in microphone
Lch
INPUT1 switch
selection is valid
(LINE/MIC select)
INPUT1 INPUT1 switch
selection is valid
(LINE/MIC select)
Built-in microphone
Lch
INPUT2 INPUT2 switch
selection is valid
(LINE/MIC select)
Built-in microphone
Lch
CH2
SELECT
switch
CH2 recording CH4 recording
INT (R) Built-in microphone
Rch
INPUT2 switch
selection is valid
(LINE/MIC select)
INPUT2 INPUT2 switch
selection is valid
(LINE/MIC select)
Built-in microphone
Rch
However, the following restrictions apply depending
on the format used.
• Refer to the section “Recording format list” (Page
164) recording format.
When the AVC-I100, AVC-I50, DVCPROHD or
DVCPRO50 format is used:
The recording mode is fixed at 4-channel
recording.
When the DVCPRO or DV format is used:
Either 2 or 4 channels can be selected using 25M
REC CH SEL on the setting menu AUDIO SETUP
screen.