Panasonic AG-HPX250EN - Manual (Page 12)

12
P2 card access lamps
■
CAMERA/PB/PC (USB HOST) mode
Lights green:
Data can be saved onto the cards or loaded from
them.
Blinks green (slow):
No available space on card, card is
writeprotected.
Lights orange:
Slot that is the object of recording.
Blinks orange:
Data is now being accessed.
Blinks orange (fast):
A card is now being recognized.
Both lamps blink orange:
Ejection of card during access.
Off:
Cards have not been inserted or formatted.
Insertion of incompatible card.
■
PC (USB DEVICE) mode
Blinks orange:
Data is now being accessed.
Off:
A status other than access underway.
P2 card access lamp
Protecting against a possible erasure
Switch the write-protect switch of the P2 card to
[PROTECT].
PROTECT
Write-protect switch
Checking photos taken (REC CHECK)
Pressing the REC CHECK button after a recording
will automatically play back the last two seconds of
the most recent clip.
Holding down the REC CHECK button will allow
you to play back up to 10 seconds.
Use this function to check that recording is
performed normally.
• The camera-recorder returns to recording
standby mode after playback.
• For clips with a playback time of 10 seconds or
less, clips earlier than the current clip are not
played back even if the REC CHECK button is
held down after returning the clip to the start.
REC CHECK button
• Note that a backup recording performed on
a backup device connected to the DVCPRO/
DV or SDI OUT connector will also record
video played back using the REC CHECK
function.
• In one-clip recording mode, the beginning
of a clip is not used as the start position for
playback after returning as far as possible
with the REC CHECK function or starting
playback while recording is paused.
Instead, playback starts from the start point
of the most recent recording operation.
Basic shooting operations (continued)