Zhone Technologies IMACS-200 - Manual (Page 103)

General Features 4-19
IMACS-200 General Features TCP/IP Network Management
Table 4-8. TCP/IP Screen Actions
Table 4-9. TCP/IP Screen Options and Defaults
HOST TYPE
The Host Type is used to control IP forwarding. When Host Type is set to gateway, IP
datagrams are allowed being forwarded. When Host Type is set to host, no forwarding is
allowed. For IP forwarding (routing) to work correctly, a route must be created in the routing
table.
DEFAULT IP TYPE
The Default IP Port setting, tells the IMACS 200 where IP packets will be sent when there is
no matching entry in the routing table. The options are none (no default route used), local
ethernet (SLIP/PPP over DB-9 serial port), wan (wan-1, wan-2, wan-3, wan-4), ipr-fr (IP
Router via Frame Relay) or SA4 (use of the 4kbps channel available for E1 customers).
Action Function
Ping Test whether the connected device responds to an echo request message.
After entering the IP address of the host device, the status line will display,
"Testing . . ." The next message indicates if the host is alive or down.
Netstat Displays the Network Statistics. See below.
rOute Shows the Routing screen. See the “Routing” section below.
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refresh Used on Testing and Monitoring screens to update statistics, and on other
screens to redraw the screen.
Main Returns to the CPU card main screen. If changes are made to settings and
not saved, you will be prompted to save or lose changes.
Parameter User Options Default
HOST IP STATE actv stdby stdby
HOST IP ADDR IP address 0.0.0.0
HOST NETMASK Network 0.0.0.0
HOST TYPE host gateway host
DEFAULT IP TYPE none local ether wan ipr-fr
SA4 local ether
DEFAULT IP SLOT n/a wan-1 wan-2 wan-3 wan-4) n/a
DEFAULT IP TS n/a table n/a
DEFAULT GATEWAY IP address 0.0.0.0
RPT1 IP ADDR IP address 0.0.0.0
RPT1 COMMUN STR blank
RPT2 IP ADDR IP address 0.0.0.0
RPT2 COMMUN STR blank
RPT3 IP ADDR IP address 0.0.0.0
RPT3 COMMUN STR blank